Cellink NEO Extended Battery Pack

PowerCell 8 Hardwire Kit:
Allows the PowerCell 8 Battery Pack to charge at a higher rate of 9 Amps, so it’s able to charge the battery in 45 minutes to full

PowerCell 8 12V Power Cable:
Easier for install, but it charges the dash camera with lower current of 5 Amps, extending the charging time to 1 hour and 20 minutes

Charge Transfer Connecting Cable:
This cable allows the Cellink NEO Extended Battery Pack to connect to another unit, be it a main battery unit and/or another Extended Battery Pack. This will allow the units to link up and transfer charge to one another.

Female 12V Cigarette Socket Output:
This should be used for BlackVue dash cams and other cameras that switch into parking mode using the G-sensor. These are cameras that switch into parking mode after your vehicle is parked for a few minutes. The BlackSys dash cams can also work with this output method if the 'Use External Power' option is enabled.

Spliced Hardwire Kit Output Harness:
This kit is designed to work with the BlackSys and Thinkware dash cams. The hardwire kit is pre-spliced by one of our technicians so that it will switch into parking mode based on the ignition. Thinkware dash cams will not switch into parking mode if the female cigarette socket is used.

Unspliced 3-Wire Hardwire Kit:
If you already have a three wire (B+, ACC, Ground) hardwire kit, you can splice it into the Cellink Battery B battery pack output yourself. This is a good option for the DIY-ers out there.

If you have any further questions, our product experts are here to help.